DIRECTIONS FOR USE

For best results, dry-vacuum carpet before cleaning. After cleaning, use fans to dry and avoid foot traffic before carpet dries. Dry-vacuum again after carpet dries thoroughly.

A: Hot Water Extraction:

1. Mix ECOgent2 20 parts water to 1 part ECOgent2
   in pre-spray unit. (200 ml ECOgent2 in 4L water, or 6.4 oz. per gallon)
2. Spray heavily soiled areas and allow a dwell time of 15 to 20 minutes.
3. Mix 12 ml ECOgent2 per 4L hot water (1/3 oz. per gallon) in extractor and extract carpet.
4. Addition of defoamer in soiled water tank may be needed.

B: Cold Water Extraction:

1. Mix ECOgent2 10 parts cold water to 1 part ECOgent2 in pre-spray unit. (400ml ECOgent2 in 4L water, or 12.8 oz. per gallon)
2. Spray all areas to be cleaned and allow a dwell time of 15 to 20 minutes.
3. Rinse carpet thoroughly with cold water only in extractor.
4. Addition of defoamer in soiled water tank is recommended.

C: Rotary Floor Machine followed by Rinse Extraction:

1. Mix ECOgent2 carpet cleaner 64 parts warm or hot water to 1 part ECOgent2. (62.5 ml ECOgent2 per 4L water or 2 oz. per gallon)
2. Scrub carpet and allow 15 to 20 minutes before rinse extracting carpet with water only.
3. Addition of defoamer in soiled water tank is recommended.

1. Apply ECOgent2 undiluted.
2. Allow time to penetrate stain.
3. Tamp with a spotting brush.
4. Rinse with extractor.
   

E: Light Daily Spotting

1. Mix 40 parts water with 1 part ECOgent2 in spray bottle. (100 ml ECOgent2 in 4L water or 3.2 oz. per gallon)
2. Spray stained area.
3. Blot dry with towel or absorbent cloth.
4. Repeat until stain no longer transfers onto cloth or towel.

F: Pad Cleaning

ECOgent2 is an outstanding choice for light duty cleaning of carpets.

1. Mix 64 parts warm or hot water to 1 part ECOgent2 in bucket and pre-spray unit. (62.5 ml ECOgent2 per 4L water or 2 oz. per gallon)
   (Note: Do not use more ECOgent2 than the recommended concentration.)
2. Dip pad in premixed cleaning solution; squeeze excess liquid from pad.
3. Spray soiled areas with pre-spray unit.
4. Pad clean, changing pads as required.

NO ANIMAL TESTING

Following the above practices will
contribute to consistently excellent results.