Rotovac / Little Giant 2HT
Printed From: Carpet Cleaning Forum
Category: Carpet Cleaners Discussion
Forum Name: Rotovac
Forum Description: Discussion about Rotovac machines.
URL: https://www.kleenkuip.com/forum/forum_posts.asp?TID=5702
Printed Date: 17/April/2024 at 10:05pm
Software Version: Web Wiz Forums 12.06 - https://www.webwizforums.com
Topic: Rotovac / Little Giant 2HT
Posted By: goomer
Subject: Rotovac / Little Giant 2HT
Date Posted: 04/March/2009 at 2:41pm
|
Hi, I am getting a Cross American Quadra-4Pack and a Rotovac. I was wondering if a Little Giant 2HT propane water heater would keep up with the constant high water output of a rotovac wand or 360? Anyone have any experience with a similar setup? Thanks |
Replies:
Posted By: FuzzSucker
Date Posted: 07/March/2009 at 12:05am
|
a propane heater can more than keep up with any system I have ever seen. Including dual wand setups.
------------- http://thepremierclean.com - http://thepremierclean.com | http://carpetcleaning-coloradosprings.com - Colorado Springs Carpet Cleaning |
Posted By: portable guy
Date Posted: 16/March/2009 at 6:27pm
|
could it keep up with a tile & grout portable? let's say mytee m-12? and if so where can I get one of those heaters? |
Posted By: Ed Valentine
Date Posted: 16/March/2009 at 6:40pm
|
Groomer;
There are quit a few who run the RECOIL (New Generation XPS) systems with a #2HT and the rotovac units with terrific results!
Especially the QUADRA 4PAK "Contractor Series".
The very best;
Ed Valentine
"Super-Charged" Systems
|
Posted By: Ken_Is_OK
Date Posted: 16/March/2009 at 10:12pm
|
what is your total investment?
couldaboughtatruckmountlol
|
Posted By: Steaminpile
Date Posted: 16/March/2009 at 10:19pm
I've used a kero burner with an RX-20,,,,,,,,,,,,,you could barely see from all the steam ------------- A.K.A. Andy |
Posted By: portable guy
Date Posted: 16/March/2009 at 10:42pm
|
yeah... I could,and I want to buy a t/m but I do a lot of commercial work mostly from 6pm till 2/3 am so I can't have windows open for security reasons, and there is a lot of 3 to 6 story buildings so for me portables are the way to go.
but I've been getting a lot of residential work too so for that a t/m would save me a lot of time, maybe in a year or two I'll get a t/m.
|
Posted By: Steaminpile
Date Posted: 16/March/2009 at 11:59pm
|
I'm a TM guy who went porty
still have the kero burner in my van............use it on nasties where I don't have to run TOO much solution line (I don't leave the porty in the van)
I really don't mind running a kick a$$ porty,,,,,I get the same job done and it's opened up a whole lot of new work for me (high security and high rises) ------------- A.K.A. Andy |
Posted By: Ken_Is_OK
Date Posted: 17/March/2009 at 7:43am
Cimex or Orbot
|
portable guy wrote:Posted By: prouddadx3
Date Posted: 17/March/2009 at 8:46am
|
If you have a hard time maintaining heat for the Rotovac just get smaller jets or turn down the water pressure. You have 6 jets working instead of two.
------------- http://maps.google.com/coupons/page?oi=lbc&did=0_14019921871367697693&cid=RF0IMWO26GG3CFHL&hl=en-US&gl=US - Boulder carpet cleaning Coupons |