Help! I'm not getting into hot water |
Post Reply |
Author | |
midlo777
Newbie Joined: 29/October/2008 Status: Offline Points: 22 |
Post Options
Thanks(0)
Posted: 25/November/2008 at 6:15pm |
I just bought a Pro Chem Power Direct with 1900 hrs
My water is only 140 deg I tried bleeding the heat transfer and it made
no difference. Not sure if I did it correctly. Any suggestions appreciated
|
|
Sponsored Links | |
Just Ol' Willy
Senior Member Joined: 20/April/2007 Status: Offline Points: 147 |
Post Options
Thanks(0)
|
You could try descaling. Depends on the water in your area.
|
|
|
|
FreshAire
Journeyman Joined: 13/May/2008 Location: Perth W. Aust Status: Offline Points: 251 |
Post Options
Thanks(0)
|
CHECK TO MAKE SURE YOUR HEAT BYPASS VALVE IS NOT LEAKING and now without capslock (oops)
|
|
John L
Carpet Cleaning Guru Joined: 29/November/2004 Location: I'm Right Here! Status: Offline Points: 4013 |
Post Options
Thanks(0)
|
It could be something simple like what tool ya using for cleaning? Maybe your flow rate is too high! Engine rpm's running too low? Make sure your anti-freeze is not low.. This would cause inadequate heat transfer to the liquid heat exchangers.. Is there a dema solenoid on it? It could be stuck in dump mode or may be loose.. Malfunctioning thermostat? Recalibrate or replace.. Exhaust leak in one of the fittings?
And what they said above! Edited by John L - 26/November/2008 at 12:47am |
|
Post Reply | |
Tweet |
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Welcome to KleenKuip.com's Professional Carpet Cleaners Discussion Forum!