Dear Ted

hell yes....lol snap crackle pop.... hope you have a spare one...lol

plug into the stove

Actually if you have two 3-stage vacuums........you will also have two cords.

Your right Steamer........thats when a circuit breaker comes in handy......lets you know if your plugged into the same circuit....saves time and heart break.......when your running around looking for the fuse box.

I think she means circuit "locator"

 

Adwa wrote: Your right Steamer........thats when a circuit breaker comes in handy......lets you know if your plugged into the same circuit....saves time and heart break.......when your running around looking for the fuse box.

Actually, it is the opposite of what you just said Steamer. Lamb Amteck motors draw their maximum amp draw when NOT under load, because that is the time that they move their maximum air flow, which is what takes the most energy. When under load by restricting the airflow as when the wand is on the carpet, airflow goes down drastically, and so does the amp draw. I have tested this many times with my meter, and it always works this way. Interestingly, PD blowers work exactly the oposite to this, increasing the energy needed as lift increases. Go figgure, eh?

You can have 5 plugs running on the same breaker and a 15 amp breaker holds about 1700 watts before it heats up and pops. So you also need to look for other things that may be plug in like computers and stuff.

When I run my ninja, I aways walk around and check all the plugs.

I have been in houses were I even had to shut over head lights off.

But I have not had that problem in offices even old ones.

what about the pump???